Aussie Saddle Pad Buying Guide
An Aussie saddle pad is a purpose-built barrier and cushion layer that sits between an Australian stock saddle and the horse, typically cut with a high wither profile and extended skirt to match the saddle's panel shape. The core trade-off is between thick, dense felt or wool for pressure distribution and thinner, contoured synthetic pads for heat dissipation and close contact. Choose a pad with a defined wither channel and a spine that matches your saddle's gullet width; generic square pads will bridge, slip, and concentrate pressure.
At a glance
- Price range
- Price range not synced yet
- Category
- Equestrian Saddles & Pads
- Data updated
- Nov 20, 2026
Current offers
Highlights
- Australian stock saddles use a half-panel or full-panel flocked tree; pads must have a high, narrow wither cutout and a drop that clears the panel edge by 1–2 inches.
- Felt pads in 3/4-inch to 1-inch dense wool felt are the standard for pressure distribution; anything under 1/2-inch compresses to near-zero protection under a 200 lb rider.
- Wool felt (100% or high-percentage) wicks and resists compaction better than synthetic fleece, which mats and traps heat after repeated use.
- Correct pad length for an Aussie saddle is 1–2 inches beyond the panel front and back—typically 24–28 inches along the spine for adult stock saddles.
Best use cases
- Best fit: trail and working stock riders needing all-day pressure relief—pick a 3/4-inch to 1-inch 100% wool felt pad with a high wither cutout and leather wear patches.
- Best fit: arena or training work in hot climates—choose a contoured synthetic or wool-blend pad with a mesh spine and 1/2-inch thickness to reduce heat buildup.
- Wrong fit: buying a square western pad and folding it—this creates lumps and bridges the stock saddle's panel; skip and buy an Aussie-specific cut.
- Wrong fit: using a thin dressage square under a stock saddle—the panel shape mismatches and causes slipping; select a pad with extended skirt and rear drop.
Buying tips
- Measure your saddle's panel length along the spine and add 2 inches; a pad shorter than the panel will rub and roll at the cantle.
- Match pad thickness to rider weight: under 150 lb use 1/2–3/4 inch felt; over 150 lb or long rides use 3/4–1 inch dense felt.
- Check the wither cutout depth—it should clear the horse's wither by at least 2 inches with the saddle mounted and girthed.
- Prefer pads with a reinforced spine and wear leathers at the stirrup and girth contact points; these are the first failure zones on cheap pads.
Specs
| Pad Material | 100% wool felt / wool blend / synthetic |
|---|---|
| Thickness | 1/2 in to 1 in dense felt |
| Wither Cutout | High narrow channel, 2 in clearance |
| Spine Length | 24–28 in for adult stock saddles |
Related searches
What to check before buying
- Measure your horse's wither height and width; confirm the pad's cutout rises at least 2 inches above the wither with the saddle on.
- Verify your saddle's panel length and skirt shape—Aussie pads are cut for half-panel or full-panel stock saddles, not western bars.
- Check girth and stirrup leather contact points; the pad must extend under the girth and not bunch at the stirrup bar.
- Confirm the pad's cleaning method—wool felt requires cold hand wash and flat drying; synthetic pads machine wash but degrade faster.
FAQ
Data sources: eBay / Amazon listings and product attribute feeds Data updated Nov 20, 2026.
Some links on this page are affiliate links. If you buy after clicking one, we may earn a commission at no extra cost to you. This does not change which products appear here or their order. Affiliate disclosure.
