Bone Swiss Bearing Buying Guide
Bone Swiss bearings are a specific grade of skateboard bearing: Swiss-pattern steel races and balls with a removable rubber shield, sold as a precision upgrade over standard ABEC-1/3 factory bearings. The real trade-off is speed versus durability: Swiss bearings spin faster and resist contamination better than cheap steels, but they require correct spacing, cleaning, and avoid impact loads. The decision rule is simple—buy Swiss-grade only if you maintain your setup and want serviceable speed; otherwise a sealed budget bearing set is the smarter durable choice.
At a glance
- Price range
- Price range not synced yet
- Category
- Skateboard Wheels & Bearings
- Data updated
- Nov 16, 2026
Current offers
Highlights
- Swiss-grade bearings use harder, more refined steel races and balls than standard ABEC-1 bearings, giving lower rolling friction and longer service life under clean conditions.
- Removable rubber shields (non-contact or light-contact) allow solvent cleaning and re-lubrication, which is the key maintenance difference versus permanently sealed cheap bearings.
- Bone Swiss are built to a Swiss precision pattern, not a formal ABEC rating; they prioritize speed and serviceability over the tight-tolerance ABEC-7/9 certification used in industrial bearings.
- Bearing performance also depends on wheel core fit and axle diameter: standard skateboard bearings are 8mm ID x 22mm OD x 7mm wide, and any deviation causes wobble or binding.
Best use cases
- Best fit: street and park skaters who clean and re-lube bearings regularly and want faster roll with serviceable shields—choose Swiss-grade with removable shields.
- Wrong fit: damp, dusty, or rain-exposed commuting where grit intrusion is constant—skip Swiss and choose fully sealed, cheap bearings you can replace without regret.
- Best fit: smooth concrete or indoor skatepark use where speed and low friction matter most, paired with correctly spaced wheels and a clean axle.
- Wrong fit: heavy impact or freestyle tricks that shock-load bearings—prioritize thicker shielded, standard steel bearings and accept lower top speed for durability.
Buying tips
- Match the bearing to your wheel core: standard 8mm axle bearings fit most skate wheels, while some longboard and specialty wheels use 10mm or bearing spacers—measure the wheel bore before buying.
- Choose removable-shield Swiss bearings only if you will actually clean them; if not, a sealed budget bearing set lasts longer with zero maintenance.
- Use bearing spacers and speed washers correctly—they prevent side-loading and extend bearing life more than upgrading bearing grade alone.
- When comparing Swiss to standard, remember Swiss bearings are not automatically faster in dirty conditions; shield type and cleaning routine often matter more than the steel grade.
Specs
| Bearing Grade | Swiss pattern vs ABEC-rated steel |
|---|---|
| Shield Type | Removable rubber vs sealed metal |
| Standard Size | 8mm ID x 22mm OD x 7mm wide |
| Maintenance | Serviceable (clean/lube) vs sealed |
Related searches
What to check before buying
- Verify your wheel bore is 22mm and axle is 8mm—standard skate bearings are 8x22x7mm, and mismatches cause wobble or seizure.
- Check that your wheels include or accept bearing spacers; riding without spacers side-loads bearings and shortens Swiss bearing life.
- Confirm you have the cleaning supplies (solvent, bearing lube, shield removal tool) if you choose removable-shield Swiss bearings.
- Assess your riding environment: if you frequently ride through grit, water, or dust, plan on frequent cleaning or choose sealed bearings instead.
FAQ
Data sources: eBay / Amazon listings and product attribute feeds Data updated Nov 16, 2026.
Some links on this page are affiliate links. If you buy after clicking one, we may earn a commission at no extra cost to you. This does not change which products appear here or their order. Affiliate disclosure.
