Slimeball Skateboard Wheel Buying Guide
Slimeball skateboard wheels are a niche sub-brand of urethane wheels known for their soft, wide profiles and slide-friendly formulas, primarily used for cruiser, filmer, and old-school pool setups. The core trade-off is soft urethane (78a–85a) for grip and vibration damping versus harder, narrower wheels for speed and slide control. Buy Slimeball-style wheels if you need a soft, wide contact patch for rough pavement or filming; skip them if you demand high-speed park performance or precise technical sliding.
At a glance
- Price range
- Price range not synced yet
- Category
- Skateboard Wheels & Bearings
- Data updated
- Nov 16, 2026
Current offers
Highlights
- Slimeball wheels typically use 78a–85a urethane, giving a soft, grippy ride that absorbs rough asphalt but wears faster than 99a–101a park wheels.
- Wide contact patches (often 36–42mm) and offset or center-set bearings increase stability but add rotational weight and slow acceleration.
- Original Slimeball formulas (e.g., 60mm/78a) are slide-friendly for cruiser lines but lack the hardness for high-impact freestyle or vert.
- Modern remakes and white-label 'slimeball' wheels vary widely in urethane grade; check durometer and bearing seat (standard 608) for compatibility.
Best use cases
- Best fit: Cruiser or filmer setups on rough streets—pick 60–65mm, 78a–80a Slimeball-style wheels for grip and shock absorption.
- Best fit: Old-school pool or bowl riding—choose 56–60mm, 80a–85a wide wheels with offset bearings for stability on transitions.
- Wrong fit: Technical street tricks or high-speed park skating—skip soft Slimeballs; choose 52–54mm, 99a–101a wheels instead.
- Wrong fit: Electric skateboards or downhill—Slimeball soft urethane overheats and chunks; use 70–80mm, 78a–80a dedicated e-board wheels or harder downhill formulas.
Buying tips
- Match durometer to terrain: 78a–80a for rough asphalt and filming; 82a–85a for pool and smooth concrete; above 85a is not a Slimeball profile.
- Check wheel diameter: 56–60mm for standard trucks with no risers; 60–65mm requires 1/8-inch risers or re-drilled deck to avoid wheel bite.
- Verify bearing seat: Slimeball wheels use standard 608 bearings (22mm OD); avoid vintage or off-brand wheels with non-standard seats.
- Choose offset or center-set bearing placement: offset for grip and stability in bowls; center-set for easier slide initiation on cruisers.
Specs
| Durometer | 78a–85a soft urethane |
|---|---|
| Wheel Diameter | 56–65mm typical |
| Contact Patch | 36–42mm wide |
| Bearing Seat | Standard 608 (22mm OD) |
Related searches
What to check before buying
- Measure your deck width and truck axle length—Slimeball wide wheels (36–42mm contact) need 149mm–169mm trucks to avoid overhang on narrow decks.
- Check for wheel bite: with 60mm+ wheels, test lean on your setup; add 1/8-inch risers if the wheel contacts the deck under hard turns.
- Confirm your terrain: soft 78a–85a urethane suits asphalt and concrete; abrasive or hot surfaces accelerate wear—expect shorter lifespan.
- Verify bearing condition and spacing: standard 608 bearings and included spacers are required; worn bearings or missing spacers cause wobble and flat spots.
FAQ
Data sources: eBay / Amazon listings and product attribute feeds Data updated Nov 16, 2026.
Some links on this page are affiliate links. If you buy after clicking one, we may earn a commission at no extra cost to you. This does not change which products appear here or their order. Affiliate disclosure.
